
Inflatable Seal Corner Details
Rectangular inflatable seal configurations can be designed for聽,听, or聽for聽. In all these cases, how the corners are designed and made is a significant step in the seal design process. Minimum corner diameters by inflatable profile聽are available as part of the聽聽section (sign-in required). When using fabric-reinforced (molded construction)聽profiles, radiused and square聽corner dimensions are largely determined by tooling availability, which can also be found in the Tooling tab within the聽听蝉别肠迟颈辞苍.
Corners for Axial Expansion
Rectangular seals designed for axial expansion are very common. A typical application would find the seal installed about 1″ from the outside edge of a sliding (or hinged) door. When the door is in position the seal will inflate against the door, which subsequently seals the opening.聽Depending on the corner dimension, an axially expanding corner (and seal) may be supplied in the following constructions:


Continuous
Axial corners (and seals) may be supplied as a continuous loop. The corner section is then bent to the radius and held in place with retainers (most commonly retainer clips) for Type 1 profiles or installed in channel as with Type 10 profiles. This is the most effective method, but can only be accomplished if the seal profile can handle the radius without kinking.
Formed
Axial corners may be formed or molded to a radius when the corner is too tight for a continuous construction. Note additional time and setup costs are typically required to build corners to this construction.
Square

Square corners are an available option for many of our popular聽听补苍诲听聽standards. For some, we also offer聽聽corners,听 which are designed to fit a square corner, but have a small radius along聽the聽inside corner to improve聽cycle聽life. Note聽all聽of聽our square corners are molded and do not employ a miter cut and splice corner construction. Using a mitre cut and splice may be less costly, but the area where the seal will see the most strain is聽where the splice is. We do not recommend this practice.
Corners for Radial Expansion Outward
Corners聽designed for radial expansion outward are the best choice for rectangular inflatable seals. As a general rule,听depending on specific profile, Pneuma-Seal and Q cross sections (either fabric reinforced or extruded) are flexible enough in radial seal applications to conform to a corner radius of between four (4) and eight (8) times its relaxed height (see聽聽for corner data by profile).聽Note square corners are not聽available for聽radial expansion outward configurations, because a 90掳聽corner would cause undue stress and premature failure.

Radial expanding rectangular seals are typically manufactured as聽a continuous loop, then installed using aluminum retainers (or clips) or simply snapped into a channel. If a channel is聽used, the seal may聽sag at the bottom of the loop, especially if the seal is over 12 LF in circumference.
Corners for Radial Expansion Inward
Rectangular seals designed for radial expansion inward are the most difficult from a design standpoint. When expanding inward, the corner must be very generous in order for it to expand properly. If the corner radius is too tight, the profile will likely wrinkle and not seal. Note square corners are not available for radial expansion inward applications, because a 90掳 corner would cause undue stress and premature failure.
Radial expanding inward rectangular seals are typically manufactured as a continuous loop, then installed using aluminum retainers (or clips) or simply housed in a channel with adhesive.